IBM x3650 - System M2 - 7947 User Manual page 78

10. Install the SAS riser-card and controller assembly (see "Installing the SAS
11. Slide the tape-drive assembly most of the way into the tape-drive bay.
12. Connect the signal and power cables from the SAS riser card to the back of
13. Make sure all the cables are out of the way, and slide the tape-drive assembly
14. Push the latch to the closed (locked) position.
62
System x3650 M2 Type 7947: Installation and User's Guide
The following illustration shows how to connect the SATA tape drive cables.
SAS riser card Tape drive power
SATA tape
signal
SATA tape
drive signal
cable
The following illustration shows how to connect the USB tape drive cables.
SAS riser card Tape drive power
Locking
collar
USB tape
drive signal
cable
riser-card and controller assembly" on page 92). Fold the excess length of the
cables under the SAS controller assembly.
the tape drive.
the rest of the way into the tape-drive bay.
Tape drive
power cable
Tape drive
power cable