Installing The Full-Length-Adapter Bracket; Storing The Full-Length-Adapter Bracket - IBM x3650 - System M2 - 7947 User Manual

User guide
Hide thumbs Also See for x3650 - System M2 - 7947:
Table of Contents

Advertisement

Installing the full-length-adapter bracket

If you are installing a full-length adapter in the upper riser-card PCI slot, you must
first install the full-length-adapter bracket in the end of the riser-card assembly.
To install the full-length-adapter bracket, complete the following steps:
1. Orient the riser-card assembly as shown.
2. Remove the full-length-adapter bracket from the storage location.
3. Align the bracket with the end of the riser-card assembly as shown.
4. Place the two hooks 1 in the two openings 2 in the end of the riser-card
5. Press the bracket tab 3 and slide the bracket to the right until it clicks into
6. Return to the adapter-installation instructions.

Storing the full-length-adapter bracket

If you are removing a full-length adapter in the upper riser-card PCI slot and will
replace it with a shorter adapter or no adapter, you must remove the
full-length-adapter bracket from the end of the riser-card assembly and return the
bracket to its storage location.
To remove and store the full-length-adapter bracket, complete the following steps:
1. Press the bracket tab 3 and slide the bracket to the left until the bracket falls
2. Align the bracket with the storage location on the riser-card assembly as shown.
3. Place the two hooks 1 in the two openings 2 in the storage location on the
50
System x3650 M2 Type 7947: Installation and User's Guide
a. Press the bracket tab 3 and slide the bracket toward the end of the
riser-card assembly.
b. Push the bracket out of the storage location on the riser-card assembly.
assembly.
place.
free of the riser-card assembly.
riser-card assembly.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

System x3650 m2

Table of Contents