Bulk Power Supply Leds; Bps Led Locations; Front Panel Leds - HP rp7420 Service Manual

Table 5-2 Front Panel LEDs
LED
Power
Standby Power
MP Present
Remote
Attention
Run
Fault
1 GPM stands for global power monitor

Bulk Power Supply LEDs

There is a single three-color LED on each BPS.
Figure 5-3 BPS LED Locations
70 Troubleshooting
Driven By State
1
GPM On Green
Off
GPM On Green
Off
GPM On Green
Off
MP through On Green
GPM
Off
MP through Flash Yellow
GPM
Off
PDC/MP On Green
through GPM
Off
PDC/MP Flash Red
through GPM
Off
Description
48 V good (LED works even if MP is not installed, or
installed and not active)
48 V off
3.3 V standby good (LED works even if MP is not installed,
or installed and is not active)
3.3 V standby off
At least one MP is installed and active
No MPs are installed or at least one is installed but not
active
Dial-in (remote) console enabled
Dial-in (remote) console is disabled, or MP is not installed,
or MP is installed and not active
Chassis log alert unread
No alert, or MP is not installed, or MP installed and is not
active
One or more partitions running
No partition running, or MP is not installed, or MP is
installed and not active
One or more partitions have reported a fault
No partitions running, or the MP is not installed, or the
MP is installed and not active