Replacing A Bps; Removing And Replacing A Pci Power Module; Extraction Levers - HP rp7420 Service Manual

Figure 6-18 Extraction Levers
3. Slide the BPS forward using the extractions levers to remove it from the chassis.
CAUTION:

Replacing a BPS

To replace a BPS, follow these steps:
1. Verify that the extraction levers are in the open position, then insert the BPS into the empty
slot. The BPS easily slides into the chassis.
2. To properly seat the connection, use a slow, firm pressure.
3. Ensure the BPS has seated by closing the extraction levers.
4. Replace the front bezel.
NOTE:

Removing and Replacing a PCI Power Module

The PCI power module is located in the front of the chassis. You must turn off system power to
replace this CRU. See
(page 84).
Use caution when handling the BPS. A BPS weighs 18 lb.
A green BPS LED indicates the BPS is operational.
"Powering Off Hardware Components and Powering On the Server"
Removing and Replacing a PCI Power Module 99