Attaching A Caster To The Server - HP rp7420 Service Manual

Table 3-2 Caster Part Numbers (continued)
Caster
Left front
Left rear
9. Locate and remove one of the four screws from the plastic pouch. Attach the caster to the
server.
Figure 3-5 Attaching a Caster to the Server
10. Attach the remaining casters to the server using the screws supplied in the plastic pouch.
11. Remove the foam blocks from the left and right side of the server.
12. Locate the plywood ramp.
13. Attach the ramp to the edge of the pallet.
NOTE:
to attach the ramp to the pallet.
14. Carefully roll the server off the pallet and down the ramp.
15. Locate the caster covers.
NOTE:
16. Insert the slot on the caster cover into the front caster. Secure the cover to the server by
tightening the captive screw on the cover at the rear of the server.
44 Installing Accessories
There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp
The caster covers are designed to fit on either side of the server.
Part Number
A6753-04006
A6753-04007