Booting The Hp 9000 Rp7420 Server; The Du Command Screen - HP rp7420 Service Manual
Hp 9000 rp7420 server - user service guide, fifth edition
Hide thumbs
Also See for rp7420:
- User manual (38 pages) ,
- Administrator's manual (266 pages) ,
- Manual (114 pages)
Table of Contents
Advertisement
To determine if the MP detects the cell boards, follow these steps:
1.
At the MP prompt, enter cm.
This displays the Command Menu. The Command Menu enables viewing or modifying the
configuration and viewing the utilities controlled by the MP.
•
To view a list of the commands available, enter he.
•
To see more than one screen of commands, press Enter.
•
To view the previous or next screen of commands, use the Page Up and Page Down
keys.
•
To exit the Help Menu, enter q.
2.
From the command prompt (MP:CM>), enter du.
The du command displays the MP bus topology. A screen similar to the following displays:
Figure 4-12 The du Command Screen
NOTE:
3.
Verify that there is an asterisk (*) for each of the cells installed in the cabinet, by comparing
what is in the Cells column with the cells physically located inside the cabinet.
Figure 4-12
physically located in slots 0 and 1.
Booting the HP 9000 rp7420 Server
After powering on the MP, +3.3 V housekeeping power, and verifying that the MP detects the
presence of the cell boards, power on the server.
If using a LAN crossover cable with the laptop, review server activity for each partition configured,
while the server powers on and boots. Windows can be opened for the complex and for each
partition. HP recommends that at least two windows be opened:
•
A window showing all activity in the complex. Following the installation procedure in this
manual causes a window to be open at startup.
To display activity for the complex, follow these steps:
1.
Open a separate Reflection window and connect to the MP.
2.
From the MP Main Menu, select the VFP command with the s option.
•
A window showing activity for a single partition.
To display activity for each partition as it powers up, follow these steps:
1.
Open a separate Reflection window and connect to the MP.
62
Cabling and Powering the Server
An asterisk (*) displays in the MP column.
shows that cells are installed in slots 0 and 1. In the cabinet, cells should be
Hide quick links:
Advertisement
Table of Contents
