Figure 3-5 Attaching A Caster To The Server - HP Integrity rx7620 Installation Manual

9. Locate and remove one of the four screws from the plastic pouch. Attach the a caster to the server.
Figure 3-5 Attaching a Caster to the Server
10. Attach the remaining casters to the server using the screws supplied in the plastic pouch.
11. Remove the foam blocks from the left and right side of the server.
12. Locate the plywood ramp.
13. Attach the ramp to the edge of the pallet.
There are two pre-drilled holes in the ramp. Use the two screws taped to the ramp to attach
NOTE
the ramp to the pallet.
14. Carefully roll the server off the pallet and down the ramp.
15. Locate the caster covers.
Chapter 3
Installing Additional Components
Wheel Kit Installation
MWK005
3/12/03
51