Removing A Hot-Plug Scsi Hard Drive - HP BL20p - ProLiant - G2 Setup And Installation Manual

2. Press the port-colored ejector lever release button (1).
3. Pull the ejector lever open (2).
4. Remove the hard drive (3).
Figure 1-13: Removing a hot-plug SCSI hard drive
To install hot-plug SCSI hard drives:
1. Remove the existing hard drive blank or SCSI hard drive from the bay:
2. Insert the hot-plug SCSI hard drive. Be sure the drive seats firmly into the
connector on the SCSI backplane.
3. Close the ejector lever.
4. If you replaced a hard drive, restore the server blade data from the backup.
5. Use the hot-plug SCSI hard drive LEDs to identify the status of the installed
drive. For more information about these LEDs, refer to the "Hot-Plug SCSI Hard
Drive" section in Appendix E, "LEDs and Switches."
6. Resume normal server blade operations.
HP ProLiant BL20p Generation 2 Server Blade Setup and Installation Guide
Installing the Server Blade and Options
1-19