Processors, Heatsinks, And Ppms; Replacing A Processor And Heatsink; Unlatching The Processor Locking Levers - HP BL20p - ProLiant - G2 Setup And Installation Manual

Installing the Server Blade and Options

Processors, Heatsinks, and PPMs

The ProLiant BL20p G2 server blade ships with one or two Intel Xeon processors.

Replacing a Processor and Heatsink

To remove a processor and heatsink:
1. Remove the server blade from the server blade enclosure. Refer to "Preparation
Procedures" in this chapter.
2. Remove the access panel. Refer to "Preparation Procedures" in this chapter.
3. Push down on the locking levers on both sides of the processor assembly, and
then rotate them up (1).
4. Remove the heatsink (2).
Figure 1-14: Unlatching the processor locking levers
1-20 HP ProLiant BL20p Generation 2 Server Blade Setup and Installation Guide