Preparation Procedures; Accessing Internal Server Blade Components - HP BL20p - ProLiant - G2 Setup And Installation Manual

Installing the Server Blade and Options

Preparation Procedures

To install server blade options, you may need to:
1. Access internal server blade components.
a. Shut down the operating system and power down the server blade.
b. Remove the server blade from the server blade enclosure.
c. Remove the access panel.
2. Identify the system board components.
WARNING: To reduce the risk of electric shock, do not power up the server
blade with the access panel removed.
3. Install server blade options.
4. Reinstall the access panel.

Accessing Internal Server Blade Components

To access internal server blade components, you must remove the access panel.
Observe the following warnings and cautions.
WARNING: To reduce the risk of electric shock, do not power up the server
blade with the access panel removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Properly
ground yourself before beginning any installation procedure. Refer to Appendix B,
"Electrostatic Discharge," for more information.
1-2 HP ProLiant BL20p Generation 2 Server Blade Setup and Installation Guide