HP BL20p - ProLiant - G2 Setup And Installation Manual page 16

To access internal server blade components:
IMPORTANT: If the server blade is not installed in the server blade enclosure or is not
receiving power through the diagnostic station, begin with step 4.
1. Identify the proper server blade in the server blade enclosure.
2. Remove power from the server blade in one of the following ways:
— Use the virtual power button feature in the iLO remote console to power
down the server blade from a remote location. Be sure that the server blade is
in standby mode by observing that the power LED is amber. For iLO
information and procedures, refer to the Integrated Lights-Out User Guide.
— Press the Power On/Standby button on the front of the server blade. Be sure
that the server blade is in standby mode by observing that the power LED is
amber.
HP ProLiant BL20p Generation 2 Server Blade Setup and Installation Guide
CAUTION: After you press the release button, the server blade is unlocked from
the server blade enclosure. Use both hands to support the server blade when
you remove it from the rack.
Installing the Server Blade and Options
1-3