Removing A Hot-Plug Scsi Hard Drive - HP ProLiant DL585 Maintenance And Service Manual

To remove a non-functioning hot-plug SCSI hard drive:
1. Press the release button to unlock the ejector lever on the hard drive (1).
2. Open the ejector lever to release the drive (2).
3. Slide the drive out of the cage (3).
Figure 2-17: Removing a hot-plug SCSI hard drive
IMPORTANT: Always populate hard drive bays starting with the lowest SCSI ID.
Reverse the steps to replace a hot-plug SCSI hard drive.
HP ProLiant DL585 Server Maintenance and Service Guide
CAUTION: Remove or replace a hard drive only when the drive failure LED is amber. Data
loss can occur if a drive is removed when the drive online LED is green. Refer to "Hot-Plug
SCSI Hard Drive LEDs" in Chapter 4, "Server Component Identification," for more information.
CAUTION: Remove or replace only one hard drive at a time. The controller relies on other
drives to reconstruct data on the replaced drive. Drive reconstruction is active when the
drive online LED is flashing green.
Removal and Replacement Procedures
2-21