Replacing A Processor Power Module; Server Blades; Removing A Ppm - HP BL20p - ProLiant - G2 Setup And Installation Manual

Replacing a Processor Power Module

To remove a processor power module (PPM), push the latches out (1), and pull the
PPM out (2).
Figure 1-19: Removing a PPM
NOTE: PPMs with the same part number may look different, but are functionally equivalent.
To install a PPM, press it into the socket until it seats firmly, and close the latches.

Server Blades

Before installing server blades for the first time, define the hardware configuration
and server blade deployment process. Refer to Chapter 2, "Configuring and
Deploying Server Blades."
HP ProLiant BL20p Generation 2 Server Blade Setup and Installation Guide
Installing the Server Blade and Options
1-25