Msata Module; Timing Module - Cisco Rugged Series Installation Manual

Product Overview
On IR8340, GigabitEthernet 0/1/0 and GigabitEthernet 0/1/1 support POE/POE+/UPOE, GigabitEthernet
0/1/2 and GigabitEthernet 0/1/3 support POE/POE+ only.
On a per-port basis, you control whether or not a port automatically provides power when an IP phone or an
access point is connected.
The 10/100/1000 PoE ports use RJ-45 connectors with Ethernet pinouts. The maximum cable length is 328
feet (100 meters). The 100BASE-TX and 1000BASE-T traffic requires CAT5, CAT5e, or CAT6 shielded
twisted-pair (STP) cable. The 10BASE-T traffic can use CAT3 or CAT4 shielded twisted pair (STP) cable.
For information about configuring and monitoring PoE ports, see the router software configuration guide on
Cisco.com.
Note

mSATA Module

Mini-SATA, or mSATA, is a low-profile interface connector that enables more effective Serial ATA (SATA)
integration in small form-factor drives roughly the size of a business card, such as solid state disks (SSDs).
The Cisco IR8340 router provides an expand slot to accommodate the mSATA module (PID: IRM-SSD-100G).
The following figure shows the mSATA Pluggable Module.
Figure 3: mSATA Module
Highlights of the mSATA Pluggable Module are:
• Provides an additional 100 GB of additional flash memory storage
• Field replaceable unit, not hot-swappable

Timing Module

The IR8340 router supports a pluggable timing module (Cisco PID: IRM-TIMING-MOD), which has the
following timing ports:
The output of the PoE circuit has been evaluated as a Limited Power Source (LPS) per IEC 60950-1.
Cisco Catalyst IR8340 Rugged Series Router Hardware Installation Guide
mSATA Module
5