Cisco IE-3000-8TC Message Manual page 72

SPANTREE Messages
error in the platform-specific code, which causes it to request more or less bits than are possible.
The first [dec] is the number of bits for the port number, and the second and third [dec] describe the
valid range.
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Enter the show version
user EXEC command to gather data that might help identify the nature of the error. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, open a case with the
TAC, or contact your Cisco technical support representative, and provide the representative with the
gathered information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page
Error Message SPANTREE-3-PORT_SELF_LOOPED: [chars] disabled.- received BPDU src mac
([enet]) same as that of interface.
Explanation
the one assigned to the listed interface. This means that a port might be looped back to itself,
possibly because of an installed diagnostic cable. The interface will be administratively shut down.
[chars] is the interface that received the BPDU, and [enet] is the source MAC address.
Recommended Action
When the problem is resolved, re-enable the interface by entering the no shutdown interface
configuration command.
Error Message SPANTREE-3-PRESTD_NEIGH: pre-standard MST interaction not configured
([chars]).
Explanation
(MST) BPDU on an interface that is not configured to send prestandard MST BPDUs. The switch
automatically adjusts its configuration on the interface and start sending prestandard BPDUs.
However, the switch does not automatically detect all prestandard neighbors, and we recommend
that you configure the interface to send prestandard MST BPDUs by using the spanning-tree mst
pre-standard interface configuration command. This warning message only appears once. [chars]
is the interface.
Recommended Action
all the interfaces to which other switches running Cisco's prestandard MST version are connected.
We recommend that you migrate all the switches in the network to the IEEE MST standard version.
Error Message SPANTREE-4-PORT_NOT_FORWARDING: [chars] [chars] [chars] [chars].
Explanation
[chars] is the mode (for example, assert or clear), and the second [chars] is the severity (for example,
minor). The third [chars] is the interface name, and the fourth [chars] is the alarm string (for
example, port not forwarding).
Recommended Action
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
Cisco IE 3000 Switch System Message Guide
2-58
Copy the message exactly as it appears on the console or in the system log.
A BPDU was received on the listed interface with a source MAC address that matches
Check the interface configuration and any cable connected to the interface.
The message means that the switch has received a prestandard multiple spanning-tree
Use the spanning-tree mst pre-standard interface configuration command on
This message appears when a port-not-forwarding alarm is set or cleared. The first
Copy the message exactly as it appears on the console or in the system log.
Chapter 2 Message and Recovery Procedures
1-4.
OL-13020-01