Cisco IE-3000-8TC Message Manual page 65

Chapter 2 Message and Recovery Procedures
Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap
[chars].
Explanation
dscp dscp-list, and ip precedence ip-precedence-list match types are supported with the match
class-map configuration command. [chars] is the class-map name.
Recommended Action
and match ip precedence class-map configuration commands within the class map.
Error Message QOSMGR-4-NOT_SUPPORTED: Action '[chars]' is not supported for a
policymap attached to output side.
Explanation
and attached to an egress interface. A warning message is logged, and the actions do not take effect.
This is a hardware limitation. [chars] is either the set or trust action.
Recommended Action
policy map and attach it to an egress interface. These policy-map actions are supported only on
ingress interfaces.
Error Message QOSMGR-4-POLICER_PLATFORM_NOT_SUPPORTED: Policer configuration has
exceeded hardware limitation for policymap [chars].
Explanation
configured more policers together in all policy maps (by using the police or police aggregate
policy-map class configuration command) than supported by hardware. [chars] is the policy-map
name.
Recommended Action
some interfaces.
Error Message QOSMGR-4-POLICER_POLICY_NOT_SUPPORTED: Number of policers has exceeded
per policy hardware limitation for policymap [chars].
Explanation
configured more policers in a policy map (by using the police or police aggregate policy-map class
configuration command) than supported. [chars] is the policy-map name.
Recommended Action
policers.
OL-13020-01
An unsupported match type was entered. Only the access-group acl-index-or-name, ip
Reconfigure the class map; use only the match access-group, match ip dscp,
A set or trust policy-map class configuration command was configured in a policy map
Do not configure a set or trust policy-map class configuration command in a
The policy-map configuration has exceeded the limitation of the hardware. You
Reconfigure the class maps or the policy maps, or delete the policy map from
The policy-map configuration has exceeded the limitation of the hardware. You
Reconfigure the class map or the policy map, and reduce the number of
Cisco IE 3000 Switch System Message Guide
QOSMGR Messages
2-51