Cisco IE-3000-8TC Message Manual page 33

Chapter 2 Message and Recovery Procedures
Error Message EC-5-DONTBNDL: [chars] suspended: incompatible remote port with
[chars]
Explanation
ports in the bundle. A port can only join the bundle when the configuration of the local port and the
configuration of the remote port are the same as other ports already in the bundle. The first [chars]
is the name of the local interface that is being suspended, and the second [chars] is the name of the
local interface that is already bundled.
Recommended Action
the bundle.
Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [chars] in group
[dec]: the interface can not be added to the channel group.
Explanation
the interface, and [dec] is the channel group.
Recommended Action
Error Message EC-5-ERRPROT2: Command rejected: the interface [chars] is already part
of a channel with a different type of protocol enabled.
Explanation
a channel with a different type of protocol enabled. [chars] is the interface.
Recommended Action
Error Message EC-5-ERRPROT3: Command rejected: the interface [chars] is already part
of a channel.
Explanation
of a channel group. [chars] is the interface.
Recommended Action
Error Message EC-5-NOLACP: Invalid EC mode, LACP not enabled.
Explanation
image.
Recommended Action
Error Message EC-5-NOPAGP: Invalid EC mode, PAgP not enabled.
Explanation
to desirable or auto.
Recommended Action
channel-group channel-group-number mode on interface configuration command.
OL-13020-01
The configuration of the remote port is different from the configuration of other remote
Make sure that the configuration of the remote ports is the same for all ports in
The interface cannot be added to the channel group with the specified mode. [chars] is
Change the channel group or the mode for the interface.
The interface cannot be selected for the specified protocol because it is already part of
Remove the interface from the channel group.
The interface cannot be unselected for the specified protocol because it is already part
Remove the interface from the channel group.
The EtherChannel mode cannot be set because LACP is not included in the software
Install a software image that includes LACP, and set the EC mode to on.
PAgP is not included in the Cisco IOS image and the EtherChannel mode cannot be set
Obtain an image with PAgP included, or set the mode to on by using the
Cisco IE 3000 Switch System Message Guide
EC Messages
2-19