Cisco IE-3000-8TC Message Manual page 34

EC Messages
Error Message EC-5-PORTDOWN: Shutting down [chars] as its port-channel is
admin-down.
Explanation
aggregate port. If the administrative state of the aggregate port is down, the administrative state of
the port is also forced to be down. [chars] is the physical interface.
Recommended Action
to activate the aggregation port.
Error Message EC-5-STAYDOWN: [chars] will remain down as its port-channel [chars] is
admin-down.
Explanation
aggregation port is administratively down, all ports in the aggregation port are forced to be
administratively down. The first [chars] is the physical interface, and the second [chars] is the
EtherChannel.
Recommended Action
port to activate (unshut) the aggregation port.
Error Message EC-5-STAYDOWN: no-shut not allowed on [chars]. Module [dec] not online.
Explanation
shutdown interface configuration command because it is a member of an EtherChannel group and
that EtherChannel group has been administratively shut down. The interface has an EtherChannel
configuration, but no information is available yet about its port channel. [chars] is the interface, and
[dec] is the module.
Recommended Action
port-channel setting of the EtherChannel.
Error Message EC-5-UNBUNDLE: Interface [chars] left the port-channel [chars].
Explanation
interface, which can be a switch port or a routed port, and the second [chars] is the EtherChannel.
Recommended Action
Error Message EC-5-UNSUITABLE: [chars] will not join any port-channel, [chars].
Explanation
as a VLAN Membership Policy Server (VMPS), for IEEE 802.1x, as a voice VLAN, or as a
Switched Port Analyzer (SPAN) destination port. All of these are unsuitable configurations for
EtherChannels. The first [chars] is the interface name, and the second [chars] describes the details
of the unsuitable configuration.
Recommended Action
Cisco IE 3000 Switch System Message Guide
2-20
The administrative state of the port is controlled by the administrative state of its
Enter the no shutdown interface configuration command on the aggregate port
The administrative state of the aggregation port overrides that of the affected port. If the
Enter the no shutdown interface configuration command on the aggregation
An interface with an EtherChannel configuration cannot be enabled by using the no
No action is required. Wait until the module is online to find out the
The listed interface left the specified EtherChannel. The first [chars] is the physical
No action is required.
One of the interfaces cannot join the EtherChannel because it is configured for PortFast,
Reconfigure the port; remove the unsuitable configuration.
Chapter 2 Message and Recovery Procedures
OL-13020-01