Tray Select; Out Of Memory Message - Oce fx3000 User Manual

Chapter 12

Tray Select

You can change the tray use only for the next
copy.
a
Make sure you are in Copy mode
.
b
Load your document.
c
Use the dial pad to enter the number of
copies (up to 99).
d
Press Tray Select.
Contrast:- nnonn+
Mode :Auto
Enlg/Red:100%
:MP>T1 c
Tray
Select d c & OK
e
Press d or c to choose the tray usage.
Press OK.
f
Press Start.
Press Tray Select
* XXX is the paper size you set in Menu, 2, 3.
Note
• T2 or #2 appears only if the optional Lower
Tray is installed.
• To change the Tray Select setting, see
Tray use in Copy mode on page 17.
82
12
MP>T1 or M>T1>T2
T1>MP or T1>T2>M
#1(XXX)*
#2(XXX)*
MP(XXX)*
Out of Memory
message
If the memory becomes full while you are
making copies, the LCD message will guide
you through the next step.
If you get an Out of Memory message while
scanning a subsequent page, you will have
the option to press Start to copy the pages
scanned so far, or to press Stop to cancel the
operation.
To gain extra memory, choose one of the
solutions below:
Print the faxes that are in the memory.
(See Printing a fax from the memory on
page 46.)
You can turn off Fax Storage.
(See Turning off Remote Fax Options on
page 64.)
Add an optional memory
(See Memory Board on page 98.)
Note
When you get an Out of Memory
message, you may be able to make
copies if you first print incoming faxes in
the memory to restore the memory to
100%.
12