Bluetooth System Settings (Wireless Model) - Olivetti ANY_WAY User Manual

BLUETOOTH SYSTEM SETTINGS (WIRELESS MODEL)

An active Bluetooth cellphone is required to use the Bluetooth connection.
Turn on the computer and insert the "Installation" CD-ROM into the drive:
1 Click Next > on the screen displayed and follow the instructions.
2 Carry out installation in USB mode. Connect the USB cable (non provided) to the printer and to the
personal computer only when requested.
3 On completing USB installation, open the Toolbox program (Start > Olivetti > Toolbox).
note: For the Mac OS X 10.2 version or higher, open the Toolbox program. It can be run from the
system finder in the list of available programs.
4 Click on the "Settings" button to access configuration of the Bluetooth parameters.
Activate Bluetooth mode and press "Send Settings" to the printer: wait for automatic reception of
the new settings (this may take several minutes).
The printer is now able to work in a Bluetooth environment.
note: If the printer has been set previously for Wi-Fi and this mode is no longer to be used (or
Bluetooth mode is to be used instead), run the Toolbox program and in the Wireless Settings
de-activate "Wireless" and press "Send Settings".
On completion, once again from Toolbox program > Settings > Bluetooth, activate Bluetooth mode
and press "Send Settings" to the printer".
Bluetooth and Wi-Fi mode cannot be activated at the same time.
Described below are the Bluetooth device setting fields:
• Enable Bluetooth: To enable or disable Bluetooth capability.
• Password: Enter a protection password for the Bluetooth connection.
The default password is 0000 so as to permit direct printing of any .jpg file transmitted by a Bluetooth
device (cellphone, personal computer, etc.) positioned in a radius of 10 meters from the printer.
• Sends Setting: To save the data in the printer.
48 CHAPTER 3