Setting Network Connection Parameters - Olivetti ANY_WAY User Manual

SETTING NETWORK CONNECTION PARAMETERS

To configure the network, the printer must have been connected in USB mode and the Toolbox
software must be installed. In the case of problems, refer to the "Printer Network Connection" and
"Before You Begin" chapters for further details of the Toolbox environment.
Toolbox is the main application that manages the available functions of the printer and, for the wireless
model, permits configuration of the network.
note: (wireless model) If the printer has been set previously for Bluetooth and you no longer wish to
use this mode (or Wi-Fi mode is to be used instead of this), run the Toolbox program and in the settings
de-activate "Bluetooth". Bluetooth and Wi-Fi mode cannot be activated at the same time.
note: "Guided installation of the printer" uses a network protocol to send and receive information.
During this exchange of information, when a firewall has been activated, certain communications may
be blocked; make sure that the network port used by the printer is "open", i.e. is unaffected by this
block (the predefined setting of the port of the printer is UDP).
In the case of irregular or discontinuous functioning, check the settings of the firewall on the PC in the
Windows 2000/XP environment. To do this, from "network resources", select the connection
concerned and using the right-hand button of the mouse access properties and then firewall settings: it
is advisable to disable the UDP port or, if in doubt, disable the protective action of the firewall.
note: The Wi-Fi settings of all the peripherals of a wireless network must be similar. This allows them to
communicate. When the printer is added to a wireless network for the first time, this cannot
communicate with network peripherals. The wireless network adapter of the printer must be
configured on the same network name (SSID), wireless channel and wireless protection key (WEP or
WPA), if used, as for all the other network peripherals.
In order to declare these parameters, the Toolbox program present in the list of applications must be
run from the computer and "Settings" must be selected.
note: The Toolbox software with the Wi-Fi settings is compatible with the Windows 2000/XP environment.
In the Macintosh OS X 10.2 or higher environment, it can be run from the system finder in the list of
available programs or double clicking on the toolbox document in the folder in which the printer
software has been installed previously.
USING YOUR PRINTER FROM A COMPUTER 43