Korg X5DR AI2 SYNTHESIS MODULE Owner's Manual page 94

Reference Guide
Pan: This parameter is used to pan the output of Oscillator1 between buses A and B. These buses
feed the effects processors. See "20A–20B Effect Placement" on page 117. When OFF is selected,
no signals are sent on buses A and B. The CNT setting means center; signals of equal level are fed
to buses A and B.
Note: When the Oscillator mode 0A is set to DRUMS, the pan settings for each drum in the kit
are used, and this parameter does not appear. See "6A–6D Drum Kit1 Setup" on page 158 and
"7A–7D Drum Kit2 Setup" on page 160.
Note: Some Multisounds have their own Pan settings and will ignore the Pan settings here,
indicating "Pan=---."
1
1D Send C, Send D: These parameters are used to set the level of Oscillator1 signal sent to buses C
and D. These buses feed the effects processors. See "20A–20B Effect Placement" on page 117.
Program
Parameters
Note: If 0A Oscillator mode is set to DRUMS, these parameters are multiplied by the
settings for
, then output to Send C and Send D. See "6A–6D Drum Kit1 Setup" on
each drum in the kit
page 158 and "7A–7D Drum Kit2 Setup" on page 160.
81