AT&T MERLIN LEGEND Release 3.0 System Programming And Maintenance Manual page 36

Accessing SPM
Modem Connections
You must make a data connection to a modem. The following modem dialing
commands are for Hayes® and Hayes-compatible modems. These may not be
the commands your modem use-refer to the user guide that came with your
modem for specific information.
If PC is in the same location as the control unit, type *10.
the
If the PC is in a remote location and your system has activated the
Remote Access feature, type the following and press (Enter
Without barrier codes type:
ATDT; the remote access telephone number; and W*10.
For example: ATDT12015551234 W*10
With barrier codes type:
ATDT; the remote access telephone number; the barrier code
preceded by a "W" and W*10. The barrier
below is 555555.
For example: ATDT12015551234 W555555
The password prompt appears on the screen
made. (You may have to press (Enter
password prompt.)
If the PC is in a remote location and your system has not activated the
Remote Access feature, do the following:
— Use the main telephone number to place a voice call to the system
on the line to which the modem is connected.
— Instruct the operator to transfer you to the modem (by pressing
Transfer, dialing *10, then hanging up the telephone).
— To put the modem on line, type ATH1 and press (Enter
up the telephone.
NOTE:
If you enter a telephone number of fewer than 11 digits, you must end it with a
pound sign (#).
18 System Programming and Maintenance (SPM)
↵
)
(Enter .
code in the example
(Enter
W*10
when the connection is
↵
) more than once to get the
↵
) .
↵
) .
↵
) , then hang