Lucent Technologies MERLIN LEGEND Reporter Installation And Use Manual page 22

Installation
1. Enter the appropriate information in the verification checklist below:
A personal computer (PC) with the recommended class, speed, RAM, and
storage configuration for your expected traffic and two available serial ports.
Make/model:
Class/speed:
Keyboard and mouse
Graphics monitor
(Check one)
95
Parallel printer and driver, setup using Printers from Windows Control
Panel on
LPT1
Serial port for SMDR input: COM
9600-baud (or faster) modem for Remote Access (for more details, see
Appendix C), installed on
serial port COM
MERLIN LEGEND II Communications System (Release 4.1 or later) with
programming options as described in Establishing the SMDR Interface later in
this chapter.
(check all that apply)
Incoming lines with Caller ID (ICLID = Individual Calling Line Identification)
We recommend purchasing this service for all incoming lines as it is useful in identifying the location
from which calls are arriving. MERLIN LEGEND Reporter supports ICLID, useful in measuring
customer response to advertising and promotions, facilitating customer callbacks, etc.
2. Verify the contents of your MERLIN LEGEND Reporter package:
This book
Remote Access software (Carbon Copy
MERLIN LEGEND Reporter software (6 diskettes):
— Setup Disk
— Program Disks 1 and 2
— Configuration Disk
— Call Collection Disks 1 and 2
D8W modular cord
355 A/F adapter (modular-to-DB25 female)
DB25-to-DB9 adapter (25-pin to 9-pin)
Issue 1 January 1997
2-4
RAM:
(indicate mouse type: bus, serial, or PS/2):
(type):
Windows 3.1 , Windows for Workgroups 3.11
, with a default configuration. DO NOT USE DISK COMPRESSION.
(check one)
or LPT2 . Printer name:
. Phone Number:
ASA or DXD
Mb Hard Disk:
SMDR Hybrid
Host - 4 diskettes)
Mb
, or Windows
or Key Mode