Table of Contents
Advertisement
Image 10-4
When switching from the dual mode to the single mode the lamp with the longest runtime is switched off.
If the runtimes are equal (if the projector has always been operated in dual mode) then lamp1 is switched out.
When switching to single mode, returning to the dual mode will not be possible in the first 60 seconds, Dual
in the menu is greyed out and LED1 is flickering, thereby preventing hot restrike which may damage the lamp.
10.3 Power mode (only active in the iQG/R 500)
What can be done ?
The lamp power mode can be chosen to be in :
•
Full power mode : the total available power is used for the lamps (maximal brightness). This corresponds with the shortest
lamp lifetime (1500 hours)
•
Economy mode : the lamps are dimmed, the lifetime is extended to 3000 hours
The choice of the Power mode must be done during the installation of the projector. The switching between the 2 modes can only be
done 6 times and this only during the first 100 hours of the lamp lifetime (considering a dual lamp mode i.e. both lamps are used).
0
Power Mode Switching
possible (max 6 times ! )
Image 10-5
Lamp power mode (projector considered to be running in dual lamp mode i.e. with both lamps on)
Above considerations and numbers (lifetimes) are only valid when functioning in dual lamp mode (both lamps
on)
How to select a Power mode ?
1. Press MENU to activate the Tool bar
2. Press → to select the Lamp item
3. Press ↓ to Pull down the Lamp menu
4. Use ↑ or ↓ to select Power Mode
5. Press → to pull down the menu
6. Use ↑ or ↓ to select the desired mode (image 10-6)
7. Press ENTER
R5976367 BARCOIQ GRAPHICS 500 01/02/2007
Lamps
replacement
Power Mode Switching
possible (max 6 times ! )
1500
100
(Full power mode)
or
3000
(econmy mode)
10. Lamp Menu
Runtime (hours)
91
Advertisement
Table of Contents
