Projector Address - Barco BarcoiQ GRAPHICS 500 Owner's Manual

13. Installation menu
Image 13-2

13.2 Projector address

What can be done ?
The projector is shipped with projector address set to "0"
In some cases the projector address must be changed, for example if an unique RCU is used to control 2 or more projectors (inde-
pendently).
In the OSD menu Projector Address, the following addresses can be programmed :
• Projector address: address defined by the user, may be from 0 to 255
0-9 is used for RCU communication, 0–255 being used for RS232 serial communication.
• Common address : address may be 0 or 1
How to change the projector's RC5 address ?
1. Press MENU to activate the Tool bar
2. Press → to select the Installation
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Projector address (image 13-4)
5. Press ENTER
A dialog box appears on the screen. (image 13-5, image 13-6)
Image 13-4
116
Image 13-3
R5976367 BARCOIQ GRAPHICS 500 01/02/2007