Gemini Installed (Only For Gemini Cadwall Systems ! ) - Barco BarcoiQ GRAPHICS 500 Owner's Manual

13. Installation menu

13.10 Gemini installed (only for GEMINI CADWALL systems ! )

When to enable ?
Gemini is option is necessary when the iQ is used in a Gemini 2 channel CADWALL system. By enabling Gemini the restrictions
relative to the allowed difference in the number of total lines are changed :
• 1 line for non interlaced sources (instead of 0)
• 2 lines for interlaced sources (instead of 1)
The default setting is NO. Never activate this option if not in presence of a Gemini CADWALL system.
How to enable Gemini ?
1. Press MENU to activate the Toolbar
2. Press → to select the Installation item
3. Press ↓ to Pull down the Installation menu
4. Use ↑ or ↓ to select Gemini installed (image 13-19)
5. Use ↑ or ↓ to select ON
6. Press ENTER
The Gemini option is enabled
Image 13-19
124 R5976367 BARCOIQ GRAPHICS 500 01/02/2007