Verifying And Troubleshooting Pluggable Optical Interfaces - Cisco CRS-1 - Carrier Routing System Router Troubleshooting Manual

Chapter 5 Troubleshooting Interfaces
late_collision: 0
rate_limit_dropped: 0
spi4_rx_frames: 0
spi4_tx_frames: 0
The following Packet-over-SONET/SDH (POS) port example shows the SPA counters. The output
displays any drop counters or error counters incrementing for the interface.
RP/0/RP0/CPU0:router# show hw-module subslot counters framer
SPA 0/0/1 device framer 0/0 info:
Egress:
Pkts
port 0
port 1
port 2
port 3
Ingress:
Pkts
port 0
port 1
port 2
port 3
SPA 0/0/5 device framer 0/0 info:
Port_1 (port 0) framer registers:
Port_1 Framer counters:
STREAM 0

Verifying and Troubleshooting Pluggable Optical Interfaces

Troubleshooting the pluggable optical interfaces includes verifying that you have an optical card
installed, enabled, and functioning properly. To troubleshoot the configured pluggable optical interfaces,
perform the following procedure.
SUMMARY STEPS
1.
2.
3.
4.
5.
OL-21483-02
Bytes Underruns
90027 213674250 0
0 0 0
0 0 0
0 0 0
Bytes CRC errs
200042 222631936
0 0
0 0
0 0
Rx Good Packets (48-bit) (#0x60286040-0x8820): 194516
Tx Byte Cnt Reg (48-bit) (#0x6028a070-0xa838): 3905343
Tx Good Bytes Cnt Reg (48-bit) (#0x6028a068-0xa834): 3112256
Tx Transmitted Packet Cnt Reg (48-bit) (#0x6028a040-0xa820): 194516
show hw-module subslot address brief pluggable-optics
show hw-module subslot address status pluggable-optics
show hw-module subslot address errors pluggable-optics
show hw-module subslot address registers pluggable-optics
Contact Cisco Technical Support if the problem is not resolved.
Verifying and Troubleshooting Pluggable Optical Interfaces
Aborts
0
0
0
0
Runts Giants
0 0 0
0 0 0
0 0 0
0 0 0
Rx Bytes (48-bit) (#0x60286078-0x883c): 3951749
Rx Good Bytes (48-bit) (#0x60286080-0x8840): 3112256
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
Aborts
0
0
0
0
5-139