Describe Command - Cisco CRS-1 - Carrier Routing System Router Troubleshooting Manual

Chapter 1 General Troubleshooting
Table^B^`89 show users Field Descriptions^B^`
Field
Line
User
Service
Conns
Idle
Location
RELATED COMMANDS
Command
show line

describe Command

The describe command provides package, component, and task ID information for a specific command.
You must be in the appropriate configuration mode for the specific command. For example, to display
the package, component, and task ID information for the router bgp 1 command, you must be in global
configuration mode.
The following example shows the output from the describe router bgp 1 command.
RP/0/RP0/CPU0:router(config)# describe router bgp 1
Package:
Component:
User needs ALL of the following taskids:
OL-21483-02
Description
All current connections. An asterisk (*) indicates the active
connection.
Username of the user logged into the line.
Physical or remote login service used.
Number of outgoing connections.
Interval (in hours:minutes:seconds) since last keystroke.
IP address of remote login host. For local (physical) terminal
connections, this field is blank.
Description
Displays the parameters of a terminal line.
hfr-rout
hfr-rout V3.3.0 Routing Package
Vendor : Cisco Systems
Desc : Routing Package
Build : Built on Tue Jan 31 10:56:38 UTC 2006
Source : By edde-bld1 in /files/3.3.0/hfr/workspace fo8
Card(s): RP, DRP, DRPSC
ipv4-bgp V[fwd-33/53]
Basic Cisco IOS XR Verification and Troubleshooting Tools
IPv4 Border Gateway Protocol (BGP)
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
1-9