Cisco CRS-1 - Carrier Routing System Router Troubleshooting Manual page 209

Chapter 9 Troubleshooting Memory
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
watchdog threshold memory [location node-id ]
minor percentage-memory-available severe
percentage-memory-available critical
percentage- memory-available
Example:
RP/0/RP0/CPU0:router(config)# watchdog
threshold memory location 0/RP0/CPU0 minor 30
severe 20 critical 10
OL-21483-02
configure
watchdog memory threshold [location node-id] minor percentage-memory-available severe
percentage-memory-available critical percentage-memory-available
end
or
commit
exit
show watchdog [memory-state | threshold memory {configured | default}] [location node-id]
Contact Cisco Technical Support if the problem is not resolved.
Purpose
Enters global configuration mode.
Configures the value of memory available for each alarm
threshold. For example, if the minor alarm threshold is set
to 30 percent, the severe alarm threshold is set to 20 percent,
and the critical alarm threshold is set to 10 percent, the node
goes into a minor memory alarm when the amount of
memory available falls below 30 percent of the total
memory on the card. In other words, this alarm occurs when
70 percent of the available memory is in use. The severe
memory alarm activates when the amount of memory
available falls below 20 percent, and the critical memory
alarm activates when the amount of memory available falls
below 10 percent.
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
Watchdog System Monitor
9-199