Configuring And Troubleshooting Line Card Interfaces; Configuration Parameters - Cisco ASR 9001 Hardware Installation Manual

Configuring and Troubleshooting Line Card Interfaces

Table 19: RSP FAIL and LC FAIL LEDs
RSP FAIL LED
Green
Blinking
Red
Off
LC FAIL LED
Green
Red
Off
Configuring and Troubleshooting Line Card Interfaces
After the person who installed the hardware verifies that the line card is working properly by examining the
LEDs, the network administrator can configure the new interface. These sections provide information on
configuring and troubleshooting the line card:

Configuration Parameters

The following table lists the default interface configuration parameters that are present when an interface is
enabled on a 10-Gigabit Ethernet line card. See Cisco IOS XR software documentation for complete information
about these parameters.
Table 20: Line Card Configuration Default Values
Parameter
Flow control
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
100
Port state is up and a valid physical layer link is
established.
Line activity is occurring. The LED blinks
green-amber-green.
Port state is up, but there is a link loss or SFP/XFP
failure.
Port is administratively shut down.
Line card has booted properly, and is ready to pass
or is passing traffic.
Line card has encountered a hardware error, and is
not passing traffic.
Line card is powered off. The LED might turn off
momentarily when switching between the states
described above, although the line card has not
powered off.
Configuration File Entry
flow-control
Troubleshooting the Installation
Default Value
egress oningress off