Download  Print this page

Operation; Reset - Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual

B-sx4t series.
Hide thumbs

Advertisement

3. ON LINE MODE

3.2 Operation

NOTE:
For the meaning of error messages
and actions to be taken, refer to
Section 5 TROUBLESHOOTING
and APPENDIX 1.

3.3 Reset

NOTE:
If the [RESTART] key is held for
less than 3 seconds when the
printer is in an error or pause
state, the printer restarts printing.
However, when a communication
error or command error occurs,
the printer returns to an idle
condition.
When the printer is turned on, the "ON LINE" message appears on the
LCD Message Display. It is shown during standby or normal printing.
1. The printer is turned on, standing by, or printing.
ON LINE
B-SX4T
V1.0A
2. If any error occurs during printing, an error message appears. The
printer stops printing automatically. (The number on the right side
shows the remaining number of media to be printed.)
NO PAPER
125
B-SX4T
V1.0A
3. To clear the error, press the [RESTART] key. The printer resumes
printing.
ON LINE
B-SX4T
V1.0A
4. If the [PAUSE] key is pressed during printing, the printer stops
printing temporarily.
remaining number of media to be printed.)
PAUSE
52
B-SX4T
V1.0A
5. When the [RESTART] key is pressed, the printer resumes printing.
ON LINE
B-SX4T
V1.0A
A reset operation clears the print data sent from the computer to the
printer, and returns the printer to an idle condition.
1. The printer is turned on, standing by, or printing.
ON LINE
B-SX4T
V1.0A
2. To stop printing, or clear the data sent from the computer, press the
[PAUSE] key. The printer stops printing.
PAUSE
52
B-SX4T
V1.0A
3. Press and hold the [RESTART] key for 3 seconds or longer.
<1>RESET
4. Press the [PAUSE] key. The data sent from the computer will be
cleared, and the printer returns to an idle condition.
ON LINE
B-SX4T
V1.0A
E3- 2
ENGLISH VERSION EO1-33058
(The number on the right side shows the
3.2 Operation

Advertisement

Table of Contents

   Related Manuals for Toshiba SX4T - TEC B B/W Direct Thermal

Comments to this Manuals

Symbols: 0
Latest comments: