Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual page 108

APPENDIX 2 INTERFACE
LAN (Option: B-9700-LAN-QM-R)
Physical Layer:
Number of ports:
Connector:
LED status:
Activity LED (Orange)
LAN cable:
Cable length:
NOTES:
1. For IP address setting, refer to the B-SX4T/SX5T Series Key Operation Specification stored in the CD-
ROM.
2. When a generally-used twisted pair Ethernet (TPE) or UTP cable is used, a communication error may
occur depending on your operating environment. In such case, you may be requested to use a shielded
twisted pair cable.
Wireless LAN (Option: B-9700-WLAN-QM-R)
Standard:
Protocol:
Security protocol:
Antenna:
Parameter setting:
Default IP address:
Default subnet mask:
NOTE:
MAC address of the Wireless LAN module will be necessary when setting the MAC address filtering function of an
access point. Please ask a service person of your nearest TOSHIBA TEC service representative.
IEEE802.3 10BASE-T/100BASE-TX
1
RJ-45
Link LED, Activity LED
Link LED (Green)
10BASE-T: UTP category 3 or category 5
100BASE-TX: UTP category 5
Segment length Max. 100 m
Conforming to IEEE802.11a, IEEE802.11b, and IEEE802.11g
IP (RFC791), ICMP (RFC792), UDP (RFC768), TCP (RFC793,896), ARP
(RFC826), HTTPD (RFC1866), TELNET, FTPD (RFC959), DHCP (RFC2131),
SNMP
WEP (64 bits/128 bits/152 bits) or AES, AES-OCB (128 bits)
TKIP (only when using WPA, WPA-PSK)
TWSL (unique encryption)
Chip type, diversity antenna
via HTTP
192.168.10.21
255.255.255.0
LED LED Status
Link ON
OFF
Activity ON
OFF
EA2- 4
ENGLISH VERSION EO1-33058
APPENDIX 2 INTERFACE
LAN status
10Mbps link or 100Mbps link is detected.
No link is detected.
* Communication cannot be made while the
Link LED is off.
Communicating
Idle