Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual page 36

2. PRINTER SETUP
2.9.1 Parameter Setting
(Cont.)
(13) Control Code Selection
This parameter is to choose a Control Code.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
CODE AUTO
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
When "CODE MANUAL" is selected and the [PAUSE] key is pressed,
the LCD display will show the setting screen of CONTROL CODE1 to
CONTROL CODE3 as follows.
<2>PARAMETER SET
CONTROL CODE1 1B
[RESTART]
[FEED]
After setting the control code for Control Code 1, press the [PAUSE]
key to show the CONTROL CODE2 screen. In a same manner, press the
[PAUSE] key after setting the control code for Control Code 2 to display
the CONTROL CODE3 screen.
CONTROL CODE1
[PAUSE]
CONTROL CODE2
[PAUSE]
CONTROL CODE3
Press the [PAUSE] key after setting the control code for Control Code 3,
and the Strip Wait Status Selection screen will appear.
E2-22
ENGLISH VERSION EO1-33058
2.9 Setting an Operating Environment
CODE AUTO
CODE ESC,LF,NUL
CODE{|}
CODE MANUAL
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 FD
CONTROL CODE1 02
CONTROL CODE1 01
CONTROL CODE1 00
Automatic selection
Manual selection
Manual selection
Control codes should
be specified.