Fitting The Fan Filter; Connecting The Power Cord - Toshiba SX4T - TEC B B/W Direct Thermal Owner's Manual

2. PRINTER SETUP

2.2 Fitting the Fan Filter

2.3 Connecting the
Power Cord
CAUTION!
1. As a Power Cord is not
supplied with the printer,
please purchase an
approved on that meets
the safety standard of
each country. (Refer to
APPENDIX 3.)
2. Make sure that the printer
Power Switch is turned to
the OFF position ( )
before connecting the
Power Cord to prevent
possible electric shock or
damage to the printer.
3. Connect the Power Cord
to a supply outlet with a
properly grounded
(earthed) connection.
When installing the printer, it is important to ensure that the Fan Filter is
attached before using the printer.
The Fan Filter consists of 2 parts:
(1) Filter Pad
(2) Filter Retainer
To fit the Fan Filter, put the Filter Pad inside the Filter Retainer and
simply press into place as shown in the diagram below, ensuring
connecting pins are aligned with the connecting holes.
Filter Pad
Snap On
Filter Retainer
1. Make sure that the printer Power Switch is in the OFF ( ) position.
Connect the Power Cord to the printer as shown in the figure below
Power Switch
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
Power Cord
[Example of US Type]
E2- 3
ENGLISH VERSION EO1-33058
Snap On
Power Cord
[Example of EU Type]
2.2 Fitting the Fan Filter
Power Cord