Hayward Pro Logic® Operation Manual page 16

Set Day and Time Filter T2-all
Wednesday 10:37P 8:30A to 4:00P
or
Filter T2-wkend
8:30A to 4:00P
Filter T2-wkday
8:30A to 4:00P
NOTE: The third and forth filter timeclocks function similarly to the first and second (respectively). Program these timeclocks
in the same manner.
Set Day and Time Spa-all
Wednesday 10:37P 6:00P to 9:00P
or
Spa-wkend
6:00P to 9:00P
Spa-wkday
6:00P to 9:00P
Set Day and Time Lights-all
Wednesday 10:37P 8:00P to 11:00P
or
Lights-wkend
8:00P to 11:00P
Lights-wkday
8:00P to 11:00P
or
Lights-CountDn
0:20
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
For one speed pumps, this is the second filter timeclock.
For two speed, this timeclock will set the normal time period for filter pump low speed operation (the
word "Filter T2" in the display will be replaced with "Filter L1"). If the filter pump is off for more than
30 seconds, the pump will first turn on at high speed for 3 minutes to prime and establish water flow.
Afterwards, it will drop down to low speed for the remainder of the programmed low speed time period.
While this time clock will override the high speed timeclock (see above), there are several reasons why
the pump will automatically switch to high speed operation during this programmed time period.
These include manual operation, spa operation, or heating operation.
For a variable speed pump, this setting will be the period of time when the pump will run at the speed
selected for speed2 in the settings menu. If there is an overlap in any of the timeclocks, then the lower
number timeclock/speed has priority.
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
This menu is only available if the system has been setup for "pool and spa-std". During the programmed
spa time, the Pro Logic will move the pool/spa valves into the "spa-only" position and turn on the
filter pump. The heater will automatically heat the spa up to the programmed spa temperature. This
programmed spa operation will take precedence over all other automatic functions, only manual
operation of the filter button or pool/spa valve button will override this function.
If your pool has a separate jet pump or blower controlled by Aux1 and/or Aux2 , you will have to
program those separately.
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
Adjust time setting
Move between start and stop times & to previous/next menu item
This menu will appear only if the Lights are configured for timeclock. The lights will turn on and off at
the designated times. The only override on this function is manual on/off control by the "Lights"
button.
Adjust time setting (Manual On/Off, 0:05, 0:10, 0:015...)
Move to previous/next menu item
This menu will appear only if the Lights are configured for countdown timer. This setting is the time
after you manually turn on the lights until the Pro Logic automatically turns off the lights. You can
also manually turn off the lights at an earlier time by pressing the LIGHTS button.
13