Hayward Pro Logic® Operation Manual page 14

Set Day and Time Set Day and Time
Wednesday 10:37P 10:37P
Set Day and Time
Wednesday 37
Set Day and Time
Wednesday 10: P
Use this function to set the current day of the week and time. These values are used for all the
automatic timeclock functions of the Pro Logic and are also displayed as part of the default menu.
The Pro Logic is designed to keep the clock running during power outages lasting less than 7 days. If
power has been off for longer than 7 days, then the time may have to be reset.
Display Light
On for 60 sec
This function controls the backlight on the display. If the "On for 60 seconds" option is selected, then
the backlight will automatically turn off 60 seconds after the last key is pressed and will stay off until
next time a key is pressed.
Note that the Display Light selection only applies to the display keypad that you are currently using.
Other display/keypads will not be affected. You need to individually set this option for each display/
keypad in the system.
Beeper
Enabled
When "Enabled", the keypad will beep every time a key is pressed. If this audible indication is not
desired, select "Disabled".
This function only applies to the display/keypad that you are currently using. You need to set this
option for each display/keypad in your system.
NOTE: This function is not supported on all display/keypads. If the "Enabled" selection is not
blinking, then the current software revision of that particular keypad/display does not support the
option and it will default to Beeper Enabled.
Teach Wireless
+ to start
Press and hold
Press any button on wireless remote
wireless button
Teach Wireless
Successful
Teach Wireless
NOT Successful
Teach Wireless
Base NOT Found
This menu will only appear if a wireless base station is connected to the Pro Logic. Perform this
procedure each time a wireless remote control is added to the Pro Logic system. During this procedure
the wireless remote "learns" and remembers the ID code for the wireless base station connected to
this particular Pro Logic unit and will reject messages with any other ID codes. If "Base NOT found"
is displayed, then the Pro Logic can not communicate with the transmitter/receiver base station
attached to the main unit. If "NOT Successful" is displayed, then the base station did not receive a
signal from the remote control. This may be due to the distance between the Base Receiver and the
remote device being too great or may be due to interference caused by other RF equipment operating
in the neighborhood. Try using the "Change Channel" command and then repeat the "Teach Wire-
less" command.
Adjust the current day of the week
Move to hours setting
Adjust the current hour (including AM/PM if applicable)
Move to minutes setting
Adjust the current minute
Move to previous/next menu item
Toggle between Always On and On for 60 sec.
Move to previous/next menu item
Toggle between Enabled (default) and Disabled Beeper
Move to previous/next menu item
Push to start process
Move to previous/next menu item
Move to previous/next menu item
Move to previous/next menu item
Move to previous/next menu item
Move to previous/next menu item
11