Hayward Pro Logic® Operation Manual page 19

A table of functions and their corresponding control parameters are listed below.
Pool/Spa
Pool Filter
Lights
Lights
Lights
Spa Filter
Aux1-14
Aux1-14
Aux1-14
Valve3
Valve4
Spa Htr1 Set
Pool Htr1 Set
Spa Htr2 Set
Pool Htr2 Set
Spa Solar Set
Pool Solar Set
SuperChlr
Note that all functions in the table may not be offered. The available functions are dependent on how the Pro Logic
is configured. For example, if the Pro Logic is configured for a single heater, "Heater2" will not be available as an
option in the Group menu. Also, under some circumstances, functions will be displayed but can't be changed.
Note that the function whose menu you are in, will not be displayed as an option and will automatically turn on
when the group is activated. For example, if programming a Group function under the Lights menu, the Lights
function will not be offered as an option and the Lights function will automatically turn on with the group.
The available control parameters vary with each function. All functions offer "Unaffected", which should be
selected if you do not wish to control that particular function within the group. All other parameters will depend on
the particular function selected.
When activating Group functions, be aware that the most recent Group function that you activate will override any
previous Group functions.
Heater Setpoints in Groups
The Pro Logic can be programmed to use alternate heater setpoints (conventional and/or solar) while running
group commands. This allows the heater to be set to a higher or lower temperature than normal, while the group is
activated. When the group stops, the setpoint will return to its normal setting.
Changing the setpoint while the Group is running will make the Group release the alternate setpoint control and
revert back to the normal heater setting. Any changes that are made at that point will affect the normal heater
setting. The next time the Group is activated, the temperature will return to the group setpoint that was originally
programmed in the Configuration Menu. To change the setpoint while the Group is running, go to the Settings menu
and press the +/- button while "Group Control" is displayed. The setpoint will change and be retained as the new
normal heater setpoint.
Function
Unaffected, Pool only, Spa only, or Spillover
Unaffected, Off, On, High, Low, On (Lowest to Highest)
Unaffected, Off, or On
(standard relay)
Unaffected, Off, On (100%, 80%, 60%, 40%, or 20%)
(dimmer relay)
Unaffected, Off or On (10% to 100%)
(VSP relay)
Unaffected, Off, On, High, Low, On (Lowest to Highest)
Unaffected, Off
(s tandard relay)
Unaffected, Off, On (100%, 80%, 60%, 40%, or 20%)
(dimmer relay)
Unaffected, Off or On (10% to 100%)
(VSP relay)
Unaffected, Off or On
Unaffected, Off or On
Unaffected, Off, 65º-104ºF
Unaffected, Off, 65º-104ºF
Unaffected, Off, 65º-104ºF
Unaffected, Off, 65º-104ºF
Unaffected, Off, 65º-104ºF
Unaffected, Off, 65º-104ºF
Unaffected, Off, On
Control Parameter
or On
16