Setting The Dc Filter; Figure 4-18 Dc Filter - Agilent Technologies U1252B User's Manual And Service Manual

Setting the DC Filter

N O T E
Agilent U1251B/U1252B User's and Service Guide
This setting is used to filter AC signals in DC measuring
paths. The DC filter is set to "OFF" by default. To enable
this function, set this to "On".
Press

Figure 4-18 DC filter

• When DC filter is enabled, the measurement speed may decrease
during DC voltage measurement.
• During AC or Hz measurement (on primary or secondary display), DC
filter will be automatically disabled.
Changing The Default Setting 4
97