Trigger Mode
This multimeter has two types of trigger mode.
• Internal — triggers measurements continuously.
• External — triggers a measurement only when a direction is given.
The external trigger is used with a delay settling that has been set by the
multimeter automatically. The amount of trigger delay varies depending on
different function. When external trigger is enabled, the multimeter
determines the range for the primary display based on the input at that
time.
Autoranging response time is required before a reading is displayed when
you change the input after a trigger is received.
Procedure
1 Press
2 Press
3 Press
4 Press
5 Press
Figure 2-10 Typical Trigger mode display
U3401A User's and Service Guide
to enter trigger mode and standby condition. The TRIG
annunciator will be lit and display is indicated with "–––––".
to get a new value. After a measurement, the result will be
indicated and held on the display.
to get a new value again.
,
necessary.
to disable external trigger operation mode.
or
to select autoranging or manual range as
Operations and Features
2
45