Figure 2-16: Wall Mount With Rotation Capability - Alvarion BreezeACCESS VL System Manual

Chapter 2 - Installation
Attach the assembled plates to the flat rear-side of the antenna. Use the two
4
remaining M5 screws to fasten them.
Fasten the antenna to the wall. Use the two #8 screws provided with the kit.
5
Do not over tighten.
Connect the antenna cable to the connector located on the bottom side of the
6
antenna. Use only the torque key supplied with the antenna. Do not over
tighten. Do not use a wrench or a similar tightening tool.
Rotate the antenna left or right so the domed surface of the antenna is facing
7
the direction of the Base Station. Check the received Signal LEDs to ensure
the antenna is aimed correctly.
60

Figure 2-16: Wall Mount with Rotation Capability

BreezeACCESS VL System Manual