Figure 2-11: Inserting The Idu Com Cable Into The Sealing Cap; Figure 2-12: Connecting The Idu Com Connector And Inserting The Sealing Cap - Alvarion BreezeACCESS VL System Manual

Chapter 2 - Installation
2.3.5.2 Units with a Waterproof Seal Supplied with the Ethernet
Cable (not applicable to new ODU)
To connect the indoor-to-outdoor cable:
Verify that the o-ring supplied with the cable kit is in place.
1
Connect the RJ-45 connector of the Ethernet cable to the outdoor unit.
2
Attach the waterproof seal to the unit. Tighten the top nut.
3
Route the cable to the location selected for the indoor equipment.
4
Assemble an RJ-45 connector with a protective cover on the indoor end of the
5
indoor-to-outdoor cable.
See Appendix D for instructions on preparing the cable.
2.3.5.3 New ODU
The sealing cap has a special groove allowing to insert an ethernet cable with
1
an already assembled RJ-45 connector through the cap. To expose the groove,
lightly squeeze the cap. Carefully insert the cable with the assembled
connector through the groove.

Figure 2-11: Inserting the IDU COM Cable into the Sealing Cap

Connect the Ethernet cable to the IDU COM RJ-45 connector.
2
Put the sealing cap back in its place. Make sure that the small protrusion on
3
the side of the cap fits inside the hole on the connector's protective body.

Figure 2-12: Connecting the IDU COM connector and inserting the Sealing Cap

Route the cable to the location selected for the indoor equipment.
4
50
BreezeACCESS VL System Manual