Verifying The Ethernet Connection (Modular Base Station); Verifying The Indoor-To-Outdoor Connection (Modular Base Station); Verifying Data Connectivity; Table 3-10: Su-I Snr Bar Led Functionality - Alvarion BreezeACCESS VL System Manual

Chapter 3 - Commissioning
LED 1 (red) is On
LED 2 (green) is On
LEDs 2 to 3 (green) are On
LEDs 2 to 4 (green) are On
LEDs 2 to 5 (green) are On
LEDs 2 to 6 (green) are On
LEDs 2 to 7 (green) are On
LEDs 2 to 8 (green) are On
LEDs 2 to 9 (green) are On
LEDs 2 to 9 (green) and 10 (orange) are On
3.5.4 Verifying the Ethernet Connection (Modular
Base station)
After connecting the unit to an Ethernet outlet, verify that the Ethernet Integrity
Indicator, which is the yellow LED embedded in the 10/100 BaseT connector, is
on. This indicates that the unit is connected to an Ethernet segment. The
Ethernet Activity Indicator, which is the green embedded LED, should blink
whenever the unit receives or transmits traffic on the 10/100 BaseT port.
3.5.5 Verifying the Indoor-to-Outdoor Connection
(Modular Base Station)
After connecting the unit to an Ethernet outlet, verify that the Ethernet Integrity
Indicator, which is the yellow LED embedded in the RADIO connector, is on. This
indicates that the unit has detected an Ethernet link connection. The Ethernet
Activity Indicator, which is the green embedded LED, should blink whenever the
unit receives or transmits traffic on the RADIO port.
3.5.6

Verifying Data Connectivity

To verify data connectivity, from the end-user's PC or from a portable PC
connected to the unit, ping the Access Unit, or try to connect to the Internet.
86

Table 3-10: SU-I SNR Bar LED Functionality

SNR Bar LEDs SNR (typical)
Signal is too low (SNR < 4 dB)
SNR > 4 dB
SNR > 8 dB
SNR > 13 dB
SNR > 19 dB
SNR > 26 dB
SNR > 31 dB
SNR > 38 dB
SNR > 44 dB
Signal is too high (SNR > 50 dB)
BreezeACCESS VL System Manual