Configuring Basic Parameters; Initial Configuration; Table 3-1: Basic Parameters - Alvarion BreezeACCESS VL System Manual

Chapter 3 - Commissioning
3.1

Configuring Basic Parameters

3.1.1

Initial Configuration

After completing the installation process, as described in the preceding chapter,
the basic parameters must be configured to ensure that the unit operates
correctly. After the basic parameters have been configured, additional parameters
can be remotely configured via the Ethernet port or the wireless link using Telnet
or SNMP management, or by loading a configuration file.
Refer to section
Telnet and how to use it.
The Basic Configuration menu includes all the parameters necessary for the
initial installation and operation of Subscriber and Access Units. In many
installations, most of these parameters should not be changed from their default
values. The basic parameters and their default values are listed in Table 3-1.
Refer to
Ethernet Port Negotiation Mode
(in Unit Control Parameters)
IP Address
Subnet Mask
Default Gateway Address
DHCP Options
Access to DHCP
ESSID
Country Code Select
Sub-Band Select (AU)
Frequency (AU)
70
4.1 for information on how to access the Monitor program using
Chapter 4 for detailed information on the applicable parameters.

Table 3-1: Basic Parameters

Parameter Default Value
Auto Negotiation
10.0.0.1
255.0.0.0
0.0.0.0
Disable
AU: From Ethernet Only
SU: From Wireless Only
ESSID1
Depends on factory
configuration
1
The lowest frequency in
the selected Sub-Band
BreezeACCESS VL System Manual
Comment
Applicable only for 5.4
and 5.8 GHz units. See
3.1.2 below.
Applicable only if more
than one Sub-Band is
available