Antenna Gain - Alvarion BreezeACCESS VL System Manual

Chapter 4 - Operation and Administration
4.2.6.2.8.5 Tx Control (AU only)
The Tx Control option enables turning Off/On the AU's transmitter, or having the
AU Tx status controlled by the status of the Ethernet port/link.
If the selected option is Ethernet Status Control, then:
If the Ethernet link is down, the AU transmitter will be switched to Off
If the Ethernet link is up, the AU transmitter will be switched to On.
This feature can be used during maintenance or testing to avoid transmissions
using undesired parameters.
The parameter is available only when managing the unit from its Ethernet port.
The default is On.

4.2.6.2.9 Antenna Gain

The Antenna Gain parameter enables to define the net gain of a detached
antenna. The configured gain should take into account the attenuation of the
cable connecting the antenna to the unit. The Antenna Gain is important
especially in countries where there is a limit on the EIRP allowed for the unit; the
maximum allowed value for the Transmit Power parameters cannot exceed the
value of (EIRP - Antenna Gain), where the EIRP is defined in the selected Sub-
Band.
In certain units with an integral antenna the Antenna Gain is not available as a
configurable parameter. However, it is available as a read-only parameter in the
applicable "Show" menus.
The lower limit for the Antenna Gain parameter is 0 (dBi). The upper limit for the
Antenna Gain is Regulation Max EIRP + 10 in dBi (since the minimum Tx Power
is -10dBm), up to a maximum of 50 (dBi). If Regulation Max EIRP is No Limit, the
upper limit is 50 (dBi). A value of "Don't Care" means that the actual value is not
important. A value of "Not Set Yet" means that the unit will not transmit until the
actual value (in the range 0 to 50) is configured. The unit can be configured to
"Don't Care" or "Not Set Yet" only in factory (when upgraded to SW version 2.0
from a lower version it will be set automatically to one of these options). Once a
value is configured, it is not possible to reconfigure the unit to either "Don't Care"
or "Not Set Yet".
The default value depends on unit type. In SUs with integral antenna it is set to
21 (read only). The default value for AUs that are supplied with a detached
antenna is in accordance with the antenna's gain. In units supplied without an
antenna the default is typically "Not Set Yet".
146
BreezeACCESS VL System Manual