Alvarion BreezeACCESS VL System Manual page 134

Chapter 4 - Operation and Administration
Table 4-3: Parameters that are not changed after Set Partial Factory/Operator
Parameters Group
Network Management Parameters
Performance Parameters
Bridge Parameters
Service Parameters
Country Code Parameters
4.2.3.2.1.3 Set Complete Operators Defaults
Select this option to reset the unit to the Operator Defaults configuration,
excluding several parameters that are listed in Table 4-2.
102
Defaults
Parameter
Wi2 IP Address (SU)
Adaptive Modulation Decision Thresholds
VLAN ID – Management
Service Provider VLAN ID (SU)
VLAN QinQ Protocol Ethertype
MAC Address List (AU)
MAC Address List Action (AU)
DRAP Option (AU)
UDP Port (AU)
Max Number of Voice Calls (AU)
DRAP TTL (AU)
Wireless Link Prioritization Option (AU)
Low Priority AIFS (AU)
Number of HW Retries for High Priority Traffic (AU)
Number of HW Retries for Low Priority Traffic (AU)
AU Burst Duration for High Priority Traffic (AU)
AU Burst Duration for Low Priority Traffic (AU)
SU Burst Duration for High Priority Traffic (AU)
SU Burst Duration for Low Priority Traffic (AU)
Low Priority Traffic Minimum Percent
Selected Country Code
BreezeACCESS VL System Manual