Removing The Water Inlet Valve - Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual

REMOVING THE WATER INLET VALVE

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the water hoses from the hot
and cold water inlet valve.
4. Remove the top cover (see page 4-2 for
the procedure).
Water Inlet Valve
5. Lift the locking tabs with a small-blade
screwdriver (see the top right photo), and
pull the wire connectors out of the hot
and cold water inlet valve solenoid termi-
nal holders. NOTE: The cold water wire
connector has a black stripe on it.
6. Loosen the clamp, and pull the water in-
let hose off the water inlet valve.
Cold Water (Stripe)
7. At the rear of the washer, remove the
screw from the water inlet valve. Slide
the valve to the right, and push it into the
washer off the rear panel.
Water Inlet Valve Screw
4-6
Lift Locking Tab
Pull Connector
Out
Solenoid
Terminal Holder
Water Inlet Valve
Inlet Hose
& Clamp