Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual page 49

10. Remove the three hex-head screws from
the lower front access panel, then lower
the panel, and remove it.
Lower Front
Access Panel
11. Open the washer door.
Bellows
Retaining Wire
12. Using a small screwdriver or a pair of
long-nosed pliers, pull the tension spring
on the retaining wire out from around
the front of the bellows, and remove the
wire.
Retaining Wire
Tension Spring
Screws
Door Switch
Assembly
13. Pull the bellows off the lip of the front
panel, and push the bellows inside the
front panel.
14. Remove the two T-20 Torx screws from
the door switch assembly.
15. Close the washer door.
16. Remove the four hex-head screws from
the top and bottom of the front panel and
remove the panel from the unit.
Continued on the next page.
4-11
Door Switch
Assembly Screws
Pull Bellows
Off Lip Of
Panel
Top Screws
Front Panel
Bottom Screws