Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual page 90

PROBLEM
NOTE: Possible Cause/Tests must be performed in the
sequence shown for each problem.
1. Unplug washer or disconnect power.
WON'T DRAIN
2. Check wire harness connections.
3. Check drain pump.
4. Check drain pump motor.
5. Check that the drain hose and drain pump filter are clear
of foreign objects.
6. Plug in washer or reconnect power.
7. Verify CCU operation by running a Diagnostic Test or
any cycle.
1. Remove shipping system.
MACHINE
VIBRATES
2. Check installation.
3. Check leveling feet.
1. Check that the inlet hoses are connected properly.
INCORRECT
WATER
2. Unplug washer or disconnect power.
TEMPERATURE
3. Check the water heater and wire harness connections
to it.
4. Check water temperature sensor for an abnormal
condition. See the Water Temperature Sensor section .
5. Plug in washer or reconnect power.
6. Verify CCU operation by running a Diagnostic Test or
any cycle.
See Failure/Error Display Codes.
DISPLAY
FLASHING
6-12
POSSIBLE CAUSE/TEST