Removing The Water Inlet Valve - Whirlpool WFC7500VW0 User Manual

REMOVING THE WATER INLET VALVE

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the water hoses from the hot
and cold water inlet valve.
4. Remove the top cover (see page 4-2 for
the procedure).
Water Inlet Valve
5. Depress the locking tabs (see the top
right photo), and pull the wire connec-
tors out of the hot and cold/bleach water
inlet valve solenoid terminal holders.
Loosen the clamp, and pull the water in-
let hose off the water inlet valves.
Cold /Bleach Inlet Valve
7. At the rear of the washer, remove the
screws from the water inlet valve. Rotate
the valve to the right, and push it into the
washer off the rear panel.
Water Inlet Valve Screws
4-4
Depress Locking Tab
Hot Water
Inlet
Valve
Solenoid
Terminal
Holder
Water Inlet Valve Screws